Reicolor ZG-02 环氧树脂锌涂料
Reicolor ZG-02 环氧树脂锌涂料是特殊环氧树脂基底漆锌涂料用于多种金属表面，如钢铁，铁，锌等。
Special epoxy resin-based primer with zinc phosphate for metallic surfaces such as steel, iron, zinc. Color shades: FK7
2 -component epoxy primer ZG-02
Special epoxy resin-based primer with zinc phosphate for metallic surfaces such as steel, iron, zinc,
light alloys, that are to be protected from attack by inorganic chemicals, diluted acids, diluted lyes,
brines, water, condensation moisture, oxidising substances and solvents. High mechanical resistance,
outstanding adhesion, particularly suitable for hot-dip galvanised surfaces.
Tested and approved in accordance with DB TL 918.300 Sheet 33 Substance No. 588.03.33 RAL
Contains solvents. Consists of component A and component B. Depending on the specific
requirements, can be coated over with practically all single and 2-component based top coats. The
high active pigment content of protects steel and iron durable indoors and outdoors.
Before use, mix component A and component B, allow to stand for approx. 30 minutes and then apply.
Supply sizes: Carton with 6 x 1 kg part A + 200 g part B
Bucket with 5.0 kg part A + 1.0 kg part B
Bucket with 10.0 kg part A + 2.0 kg part B
Bucket with 20.0 kg part A + 4.0 kg part B
Order No.: ZG-02.01.0000.0 component A
ZE-01.00.0000.0 component B
Supply form: ready for use in combination of component A + component B
Supply: as two-component primer in 2 separate containers
and matched parts by weight.
Mixing ratio: 5 parts component A + 1 part component B by weight
Pot life: approx. 6 hours, use prepared material within this time!
Drying time (20 °C): approx. 24 hours
Over-paintable: after only 2 – 3 hours
Application: brushing, rolling, spaying
Mix component A with component B well just before use and
apply immediately. The primer is ready for use only after
thorough mixing. Observe the pot life!
Heat resistance: approx. 100°C, briefly 150°C
Thinner addition: Select spraying parameters so that no thinning is necessary.
Density, mixed: approx. 1.2 g/cm³, depending on colour
VOC – EU limit value, mixed: Cat. A/j: 550 g/l (2007), 500 g/l (2010).
This product contains max. 500 g/l VOC.
Coat thickness: min. 30 µm per coat
Flash point: over + 21°C
Coating recommendation: 2 x ZG-02 + 2 x ZL-23 for decorative surfaces
2 x ZG-02 + 2 x ZL-22 for corrosion protection systems
Gloss level: matt
Application: outdoor and indoor
Colours: white, black, grey-green, yellow-orange, red-brown, dark
grey, light grey, see colour card No. 7 (no DB colours)
Consumption: approx. 150 – 200 g/m²
Substrate: If necessary, clean until free from dirt, rust, moisture, loose
Pretreatment of the zinc substrate: Closely observe information in ReiColor Technical Data
Sheet No. 29. paragraph 2.1 to 2.6, and EN ISO 12944.
Shelf life: min. 12 months from date of manufacture
Safety and risk designation: see safety data sheet